Maurivin PDM Ab Biotek Wine/Fruit Yeast 500g
Maurivin PDM Ab Biotek Wine/Fruit Yeast 500g
Maurivin PDM is a selected active yeast for medium-intensity aromas that it imparts to wine, and also for the fact that it can work at slightly lower temperatures than other products in the AB Mauri/Maurivin range.
Yeast type: Saccharomyces cerevisiae (var. bayanus)
Recommended for: white wines, red wines and rosés; also recommended for secondary fermentation - in the case of sparkling wine production.
Oenological properties of Maurivin PDM yeast
Fermentation rate
Due to its vigor, Maurivin PDM is suitable for fermentations at low temperatures. It is a very persistent fermenter at temperatures of 8 - 15 degrees C (fermentation lasting even more than 20 days here) and ferments very rapidly at 20 - 30 degrees C.

Fermentation at very high temperatures can lead to depletion of free amino nitrogen in the must. In this situation, nitrogen addition is recommended.
Alcohol tolerance
Maurivin PDM has an alcohol yield of up to 15-17% (v/v)
Volatile acidity
Generally it is less than 0.3 g/L.
Flocculation
Maurivin PDM settles excellently after fermentation.
Foam formation
Maurivin PDM forms low to moderate level foam.
Amount of SO2 produced
Maurivin PDM is considered a moderate SO2 producer (up to 40 mg/L total SO2).
Contribution to the wine
Maurivin PDM is a yeast that induces low or moderate aroma levels in the musts in which it is used. It is recommended to use when you want only a subtle note of aromas in the wine.
It is a general product that can be used with varieties such as Chardonnay, Chenin Blanc, Sauvignon Blanc, Semillon, Riesling, Cabernet, Merlot, Shiraz.
Maurivin PDM yeast is also suitable for use with the champenoise method.
How to apply Maurivin POP product?
The recommended dose is 20 - 40 grams / 100 liters of must. According to the scheme proposed by the manufacturer we will have the following application method (calculated for using the entire 500 gram package at 2500 liters of wine):
- Heat a container with 5 liters of water to 35-40 degrees Celsius;
- Then dissolve the 500 gram package of Maurivin POP yeast in the 5 liters of water;
- Let it sit for approximately 15 minutes to form the starter;
- Stir constantly
- Extract 10 liters of must and pour it over the resulting mixture;
- The temperature of the new mixture should be 15/18 degrees C. If the must is colder, it is recommended to heat it so that we obtain a temperature of the new mixture at 15/18 degrees C.
- The new mixture will be poured into the 2500 liter wine container.

Starting from their rule, by analogy, we can make the calculation regarding dissolution in 100 liters of wine. We will follow the following steps, using 30 grams yeast / 100 liters of wine.
- Heat a container with 300 ml of water to 35 - 40 degrees Celsius;
- Then dissolve 30 grams of yeast in the already heated water;
- Stir and let sit for 15 minutes to form the starter;
- Stir constantly;
- Extract 600 ml of must and pour it over the resulting mixture (starter)
- The temperature of the new mixture should be 15/18 degrees C. If the must is colder, it is recommended to heat it so that we obtain a temperature of the new mixture at 15/18 degrees C.
- The new mixture will be poured into the 100 liter wine container.
Ab Biotek